ARC STUDS
NO THREAD NT
D | MIN L | E | F | D | B | G | M |
3/16 | 25/32 | 9/32 | 3/32 | .390 | .305 | .234 | .390 |
1/4 | 25/32 | 23/64 | 7/64 | .454 | .380 | .234 | .390 |
5/16 | 25/32 | 7/16 | 7/64 | .578 | .445 | .281 | .437 |
3/8 | 25/32 | 1/2 | 1/8 | .637 | .505 | .281 | .437 |
7/16 | 25/32 | 19/32 | 5/32 | .703 | .585 | .234 | .422 |
1/2 | 13/16 | 11/16 | 3/16 | .795 | .650 | .281 | .469 |
5/8 | 31/32 | 7/8 | 1/4 | 1.030 | .785 | .328 | .516 |
3/4 | 1-15/64 | 1-11/16 | 5/16 | 1.215 | 1.030 | .469 | .656 |
7/8 | 1-1/2 | 1-1/8 | 11/32 | 1.408 | 1.210 | .545 | .732 |
1 | 1-41/64 | 1-3/8 | 3/8 | 1.615 | 1.406 | .633 | .820 |
DIAMETER: Available in diameters from 3/16" through 1”.
LENGTH: Available in required lengths above the recommended standard minimums (L). Length is before weld. Stud diameters 1/2" and smaller will be approximately 1/8" shorter after welding. Diameters of 5/8" and larger will be approximately 3/16" shorter after welding
MILD STEEL: Low carbon steel.
STAINLESS STEEL: Type 304 is the most commonly used. Other grades of stainless steel (except Type 303) are available when required.
FERRULES: All orders for studs include required ferrules.
PLATING: Plated studs are available in cadmium, zinc, and nickel, ASTM specifications A165 Type TS, A164 Type RS, and B-456. The welding end of the stud is not plated to prevent weld contamination. Information on other plating materials are available upon request.
ANNEALING: Stud ductility can be increased by annealing to 75 Rockwell B for low carbon steel and 90 Rockwell B for stainless steel.
FLUX: Studs 1/4" and over are solid fluxed.